Lotus 7 Clone D Modified SCCA
#3
Full Member
iTrader: (4)
Join Date: Jun 2011
Location: golden valley, az
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
Very nice! is it my imagination or is your engine set back, and if so how did you relocate the shifter? am putting a t2 engine in mine this summer and can move it back about 5" but will have to relocate the shifter forward the same amount and relocate the starter to the top of the bell housing. More pictures would be wonderful, see some really neat things on your build.
#5
Junior Member
Thread Starter
Join Date: Nov 2007
Location: Indiana
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
I set the motor back as far as I could manage without doing a shifter mod. It works well in a "Book" chassis. Also shifted it about 6 inches to the passenger side for chassis balance and foot room.
...Mark
...Mark
#7
Junior Member
Thread Starter
Join Date: Nov 2007
Location: Indiana
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Very nice! is it my imagination or is your engine set back, and if so how did you relocate the shifter? am putting a t2 engine in mine this summer and can move it back about 5" but will have to relocate the shifter forward the same amount and relocate the starter to the top of the bell housing. More pictures would be wonderful, see some really neat things on your build.
...Mark
Trending Topics
#9
Junior Member
Thread Starter
Join Date: Nov 2007
Location: Indiana
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
More info can be found at my build log page here:
http://www.locostusa.com/forums/view...hp?f=35&t=3356
http://www.locostusa.com/forums/view...hp?f=35&t=3356
#11
Full Member
iTrader: (4)
Join Date: Jun 2011
Location: golden valley, az
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
Love the way you have thought about access for quick repairs. Mine is road only but these things are high maintenance due to light weight and sometimes hard usage. Would love to be able to quickly remove my cowl. Your firewall location gave me the false impression that the engine was further back than it is. Your design and workmanship are outstanding. bookmarked your build and will spend some time there later,
#14
I actually own Rotaries
iTrader: (40)
you have any sound clips? I would love to hear what that exhaust set up sounds like
#17
Junior Member
Thread Starter
Join Date: Nov 2007
Location: Indiana
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Yes. Still playing with the carb. I'm running a 48 IDA with a pure stock 12A and custom header complete with 3" pre and main silencers. This is just a chassis development motor until my bridgeport race motor gets built. The idle jets are a bit rich. I only have them open 1/4 turn but it runs!
#25
Junior Member
Thread Starter
Join Date: Nov 2007
Location: Indiana
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Some vids of the last few autocrosses. The RB presilencer and muffler work very well. The car sounds really good at idle and stays within sound limits at full song.
+1 cone in Chicago
Clean run Camera B
Fastest Index run on short course
+1 cone in Chicago
Clean run Camera B
Fastest Index run on short course