Anybody have oil pan backing plates?
#1
No distributor? No thanks
Thread Starter
iTrader: (6)
Join Date: Oct 2003
Location: Outskirts of Road Atlanta
Posts: 3,438
Likes: 0
Received 6 Likes
on
4 Posts
Anybody have oil pan backing plates?
My 13B block from my 2, which I didn't build, has load-distributing brackets under the oil pan, running around the flange. It's a 6-piece set and goes between the bolt heads and the pan flange. Unfortunately, I've actually lost one somewhere, and looking to see if someone has a front-right bracket (front-left will work too). Were they original equipment on anything? All the 1st gens I've checked in junkyards just had bolts and an oil pan.
#2
RX for fun
iTrader: (13)
I didnt even use those brackets in my last 13-B install on a RX-2. I used mckenna brand silicone only; no gasket. They are much stronger than those silly tube ones from pep-boys or autozone. If you still want to use it, just fabricate a 2 long/2 short ones and dont worry about the corners.
Thread
Thread Starter
Forum
Replies
Last Post
smikels
2nd Generation Specific (1986-1992)
3
08-18-15 01:26 PM