sitting ENGINE...
#1
GETTING THE FD ROLLING
Thread Starter
Join Date: Jun 2006
Location: where ever i am
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
sitting ENGINE...
I have a ENGINE that has been sitting out of a car for about a year an a half. It is a single turbo conversion 3mm ported . I just got a roller to put it in. The ENGINE was in a garage on a crate. It has sitting there with no fluids and no oil in it. When I turn it there still a puff. So I am hoping the compression is good
1. What should i do in order to have it up an running.
2. While it is out is there any way I can check the seals?
3. Are should i go an change the seals out now while the motor is out of the car?
4. Should i change the vacuum hoses out as well?
Open to any help or opinions
1. What should i do in order to have it up an running.
2. While it is out is there any way I can check the seals?
3. Are should i go an change the seals out now while the motor is out of the car?
4. Should i change the vacuum hoses out as well?
Open to any help or opinions
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM