New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

gettin my car running again.

Thread Tools
 
Search this Thread
 
Old May 19, 2009 | 09:07 PM
  #1  
gcarpjeep's Avatar
Thread Starter
Can Post Only in New Member Section
 
Joined: May 2009
Posts: 3
Likes: 0
From: Philadelphia
gettin my car running again.

so i had an 87 rx7 given to me for free and i couldn't pass that up. its a gxl model and after changing out the plugs, oil, coolant, and battery, i got it started up. after burnin through 1 year old gas and gettin to somethin fresh it runs great. then i noticed the clutch didn't work at all, the pedal drops to the ground. seems the slave cylinder is shot (theres fluid all over it from under the seal). i figure i might as well replace both cylinders.

heres where my question comes in: i noticed that the shifter felt like crap, all loose and jiggly. i removed the center console bits enough to remove the shift lever and noticed that there were no bushings present and the "well" that the shifter sits in was full of fluid. i can find the bushings easy enough, but whats with that fluid in there? is that a sign of a bigger tranny problem?
Reply
Old May 20, 2009 | 09:25 AM
  #2  
Aaron Cake's Avatar
Engine, Not Motor
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
The fluid is transmission oil. It is there to lubricate the shifter.

Instead of burning through the old fuel, the proper way would have been to drain it. Injector problems will likely result.

Procedures to properly remove a car from storage:
http://www.aaroncake.net/rx-7/unstore.htm
Reply
Old May 21, 2009 | 10:49 AM
  #3  
gcarpjeep's Avatar
Thread Starter
Can Post Only in New Member Section
 
Joined: May 2009
Posts: 3
Likes: 0
From: Philadelphia
thanks for the help, man. i reseached and found out that that was lubricant in there. as far as the injectors, i'll have to cross my fingers, draining the fuel would have been a good idea, but the car was pretty much totally on empty and i poured about 6 gallons of fresh in there.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
stickmantijuana
Microtech
5
Aug 23, 2015 11:04 AM
smikels
2nd Generation Specific (1986-1992)
3
Aug 18, 2015 01:26 PM
rx7brandon
General Rotary Tech Support
3
Aug 16, 2015 10:55 AM
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM




All times are GMT -5. The time now is 09:24 PM.