Electric oil metering block off!!!!
Thread Starter
Can Post Only in New Member Section
Joined: Feb 2009
Posts: 1
Likes: 0
From: san antonio texas
Electric oil metering block off!!!!
Hi im chance. I have a slight problem. my oil metering pump step motor went out on me and i went ahead and blocked it off. the problem is its electric and throws my car into limp mode or check engine pops up and runs ugly. i turn off the car and restart it runs fine till it throws the code. How do i bypass an electric pump? Please help me!!!!!! Its an S5 engine
As per this thread:
https://www.rx7club.com/2nd-gen-archive-72/omp-pre-mix-mod-write-up-436722/ Post number 68/69.
They say that you need to leave your OMP plugged into the wiring harness.
https://www.rx7club.com/2nd-gen-archive-72/omp-pre-mix-mod-write-up-436722/ Post number 68/69.
They say that you need to leave your OMP plugged into the wiring harness.
If the pump is dead on an S5, you can't just use a block off plate and leave it plugged in. The ECU will continue to throw a code because the pump isn't working. You will have to buy a new pump.
The people that use a blockoff and keep the pump plugged in off to the side, have working pumps.
The people that use a blockoff and keep the pump plugged in off to the side, have working pumps.
if ya buy a rtek chip you can leave the pump unplugged.
http://www.pocketlogger.com/index.php?pid=rtek7
http://www.pocketlogger.com/index.php?pid=rtek7
Thread
Thread Starter
Forum
Replies
Last Post
rotor_veux
2nd Generation Specific (1986-1992)
7
Aug 31, 2015 07:49 PM




