coolant issue
Joined: Jul 2013
Posts: 2,596
Likes: 799
From: █▬█ █▄█ █▬█ █▄██▬█ █▄█ █▬█ █▄█
1. Raise front of car so higher than rear.
2. Remove rad cap.
3. Heater: full blast, set to hot
4. fill with coolant.
5. run engine.
6. watch pretty bubbles pop and gurgle at radiator opening.
7. run for 15min at idle, top off as necesarry.
8. put cap on rad.
9. lower car
2. Remove rad cap.
3. Heater: full blast, set to hot
4. fill with coolant.
5. run engine.
6. watch pretty bubbles pop and gurgle at radiator opening.
7. run for 15min at idle, top off as necesarry.
8. put cap on rad.
9. lower car
At least on the 1993 and newer models, the coolant level in the filler neck will always drop a few mm after the cap is removed, but that is normal. Otherwise, yes both should be full.
Thread
Thread Starter
Forum
Replies
Last Post
EliteRotaryShop
Elite Rotary Shop
0
Feb 29, 2016 07:50 AM
BLK 93
3rd Generation Specific (1993-2002)
5
Feb 26, 2016 05:15 PM
octanepwr
3rd Generation Specific (1993-2002)
0
Feb 19, 2016 11:44 PM