RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)

- New Member RX-7 Technical (https://www.rx7club.com/new-member-rx-7-technical-256/)

- - coolant issue (https://www.rx7club.com/new-member-rx-7-technical-256/coolant-issue-1097298/)

orx713

03-08-16 02:03 PM

coolant issue

Hi all,

The level of the coolant it has to be full in both taps?

FührerTüner

03-08-16 03:04 PM

Quote:

Originally Posted by jjcobm (Post 10222059)

1. Raise front of car so higher than rear.
2. Remove rad cap.
3. Heater: full blast, set to hot
4. fill with coolant.
5. run engine.
6. watch pretty bubbles pop and gurgle at radiator opening.
7. run for 15min at idle, top off as necesarry.
8. put cap on rad.
9. lower car

Sgtblue

03-09-16 04:10 AM

At least on the 1993 and newer models, the coolant level in the filler neck will always drop a few mm after the cap is removed, but that is normal. Otherwise, yes both should be full.

TomU	03-09-16 08:35 AM

Liquid will find it's own level, so filling one will fill the other and the fluid will be level if the openings are level.

orx713

03-09-16 01:53 PM

Thanks for the replay guys

All times are GMT -5. The time now is 10:04 PM.