air box screw removal tips when they just spin and don't release
#1
Full Member
Thread Starter
Join Date: Aug 2003
Location: nanaimo ,BC ,canada
Posts: 127
Likes: 0
Received 0 Likes
on
0 Posts
air box screw removal tips when they just spin and don't release
I have a couple air box screws that I cant seem to get out they just spin and won't release im guessing there is a nut that is not grabbing but I'm not sure how the screws are held any tips to get these out ? FC air box
#2
Have RX-7, will restore
iTrader: (91)
There is a nut that's pressed into the plastic that the upper bolts thread into. Often times the nuts will spin when they no longer hold in the plastic. You can apply some gentle upward pressure between the lid and the lower portion where the air filter sits to see if it will grab when attempting to remove the bolt. Sometimes that works and sometimes it does not. Sometimes the nut will come out still attached to the bolt. The nut is cylindrical with a knurled edge. Often times you wind up having to replace the airbag assembly.
#4
Have RX-7, will restore
iTrader: (91)
The stock system is actually pretty good. It uses a duct that runs along the top of the fan shroud that draws fresh air into the air box. This is is cooler than engine bay ambient air as with an open cone style filter. Better for volumetric efficiency, though quieter. I would personally order a replacement air box if you are unable to repair your current one.
Thread
Thread Starter
Forum
Replies
Last Post
attomica
2nd Generation Specific (1986-1992)
5
09-13-02 05:07 PM
Xentrix
2nd Generation Specific (1986-1992)
1
09-18-01 09:17 PM