New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

93 RX7 Won't turn over

Thread Tools
 
Search this Thread
 
Old Jul 25, 2013 | 11:02 PM
  #1  
flyer037's Avatar
Thread Starter
Junior Member
 
Joined: Aug 2009
Posts: 5
Likes: 0
From: Utah
93 RX7 Won't turn over

Hey all. My 93 RX7 was running fine all day. I probably drove it about 20 miles today running errands including a good wash and interior detail. I stopped to take some pictures in a parking lot since it looked so nice but when I got back in and turned the key...nothing happened. The lights lit up on the dash, the headlights lift up and turn on, the fan for the heat ran fine, but the engine doesn't even ATTEMPT to turn over.
Any ideas? I'm really confused since it hasn't been a problem and there were no signs that the starting was going out or anything. Not really sure what to look for. I'm not an electrical guy at ALL.
Appreciate any help!
Thanks!
Reply
Old Jul 26, 2013 | 08:00 AM
  #2  
Sgtblue's Avatar
Urban Combat Vet
Tenured Member: 20 Years
Liked
Loved
Community Favorite
iTrader: (16)
 
Joined: Oct 2003
Posts: 12,160
Likes: 983
From: Mid-west
Sounds like you have the not-uncommon issue described in this thread https://www.rx7club.com/3rd-generati...-relay-872841/
I'm not an electrical guy either, but apparently there's a relay that Mazda used that causes a voltage drop to the starter. I think it's aggravated by a battery that's getting older (lower output), poor engine/chassis grounds etc. That thread offers a solution, and Pettit Racing also offers a little loom designed to cure the issue.... RX7 Starter Booster
I had the issue occasionally when my battery was toward the end of it's life span. Would take 2 to 5 clicks before starter would engage. New(er) battery now and added some auxillary grounds...chassis to engine, engine to battery, battery to chassis. Haven't had a problem since.
Reply
Old Jul 26, 2013 | 01:16 PM
  #3  
flyer037's Avatar
Thread Starter
Junior Member
 
Joined: Aug 2009
Posts: 5
Likes: 0
From: Utah
Even easier issue than that! The stop on the clutch pedal that pushes the interrupter switch in broke, so I taped a penny to it. Problem solved! Cheapest car repair ever!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Jeff20B
1st Generation Specific (1979-1985)
4
Jun 26, 2016 10:21 AM
PhillyFC
General Rotary Tech Support
9
Aug 21, 2015 06:36 PM
Sharkbait24
New Member RX-7 Technical
1
Aug 12, 2015 10:36 AM




All times are GMT -5. The time now is 10:24 PM.