Hi i am using the S5 engine,

does anyone know for the TPS sensor the S5 has two right?(6 wires) , how am i suppose to hook it up to the microtech , i mean which one should i be using? or do i splice the wire from microtech and connect both of them?

one tps sensor disconnects halfway while the other is always in contact until WOT

 

Anyone please?

 

use the full range side of the tps, or use an S4 one

 

follow the wiring diagram???!!!??

 

I'd have to look at my friend's wiring on his 1991 TII. He's using the full range TPS.

 

It's pointless. If you read the manual, you'd see that the TPS is only used to switch between idle and load.

 

I use the full range tps for two other applications beside the microtech. Im sure they have there reasons to. Its not as "pointless" as you think. Even if it is just for the microtech then some people like to have an accurate datalog.

 

Yeah, that is correct.

 

ok so i just hook up the full range and ditch the one that disconnects halfway correct? great thanks.

btw the two tps i have , one is the full range while the other is not... the one that is not matches the color code on the MT wiring diagram but not the full range one....can i assume that both of it can be hooked up the same way?

 

I just disconnected the other one all together. Ill get you some color info tomorow as far as what wores to connect.

 

hey thanks crusader... msg me if u are online =)

 

Ohk i got the colors for s5s who want to use the full range tps. Color goes Microtech-Sensor.
Blue-Red
Gray-Yellow
Brown-Blue

 

thank you so much ... appreciate it..