Microtech TPS selection?
#1
Senior Member
Thread Starter
Join Date: Jul 2004
Location: kansas
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
TPS selection?
Hi i am using the S5 engine,
does anyone know for the TPS sensor the S5 has two right?(6 wires) , how am i suppose to hook it up to the microtech , i mean which one should i be using? or do i splice the wire from microtech and connect both of them?
one tps sensor disconnects halfway while the other is always in contact until WOT
does anyone know for the TPS sensor the S5 has two right?(6 wires) , how am i suppose to hook it up to the microtech , i mean which one should i be using? or do i splice the wire from microtech and connect both of them?
one tps sensor disconnects halfway while the other is always in contact until WOT
#7
Rotary Enthusiast
I use the full range tps for two other applications beside the microtech. Im sure they have there reasons to. Its not as "pointless" as you think. Even if it is just for the microtech then some people like to have an accurate datalog.
Last edited by Crusader_9x; 12-20-04 at 02:11 PM.
Trending Topics
#9
Senior Member
Thread Starter
Join Date: Jul 2004
Location: kansas
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
ok so i just hook up the full range and ditch the one that disconnects halfway correct? great thanks.
btw the two tps i have , one is the full range while the other is not... the one that is not matches the color code on the MT wiring diagram but not the full range one....can i assume that both of it can be hooked up the same way?
btw the two tps i have , one is the full range while the other is not... the one that is not matches the color code on the MT wiring diagram but not the full range one....can i assume that both of it can be hooked up the same way?
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM