I can say I am competant In crimping, wiring etc (who Isn't)? But providing I fit the harness with order and wire In the respective sensors, whats a good time length one can achieve or expect?

Also, how long did It take you? Experiences? Sticking points?

 

from what ive heard, 4 hours with no problems, and everything you need handy. 5 hours with going to autozone to get some crap

Daniel

 

Sticking points:

Removal of UIM/TB and gasket removal.
Getting drunk while doing and being lazy.

Don't crimp BTW, solder is your best bet. Don't use tap-ins either, I tried those on a few wires and it just sucked...I ended up pulling, cutting and soldering those.

You want a TIME SAVER? I swear by this thing, auto wire strippers. They cost around 12-15 bucks and strip wires in under a second once you get used to the hang of it...perfect everytime too!

 

Crimping. I did say that. Thats a violation of Microtech's standards, In terms of Installation. I mean't to say solder In. Anything less, would be punishable by a beating.

 

Dpends on how long the $!%$% takes to get here!

 

^^^what he said.

 

woah... talk about dissatisfied customer

 

Mine finally made it back to Jon's today. Now the harness has to make it there and it will be shipped out next wednesday (I hope)