can I use a 60-2 wheel alone? and how I set everyting in ms2 extra for the ignition? thanks!!!

 

You can use a 60-2 wheel, but it'll most likely require some mods to the v3 VR conditioner if you want to go over 6000 rpms.

How you set the ignition settings depends on what engine, what coil setup, how you mount the wheel, etc...

Ken

 

you know the mod for this? I whant the redline to be 9500rpms, my setup is a 13b cosmo semipheriferal engine ,gt45 turbo,and whant to use 4 coils,2 for leading in waste spark and 2 for trailing (just like the turbo2) maybe I will use 3 msd 6a for spark but not sure,I think that it, thanks for the help litle confuse with the wiring too I do not know how to wire the coils... thanks,Frank

 

yea, the mod would be to cut every other tooth off the wheel, so it would become a 30-1 :-)

 

what if I use a 36-1? and the wiring? how I conect the coils? I not found that in any place thanks for your time,Frank

 

You've likely not found it anywhere b/c most people just use the stock CAS.

You probably won't have to modify the built-in conditioner with 36-1.

Ken

 

chango use a turbo 2 cas. if you need you let me know i would sell you 1 for a good prices.

 

ok I got a cas from a turbo II, what I have to do to make it work?

 

Check the FAQ. It's well documented.