Megasquirt Diypnp
#26
MegaSquirt Mod
1k-4.7k should work.
I used 4.7k ones on my normal MS v3 for the rx7 because I had some problems with 1k ones on a friend's car, but most people are fine with 1k.
Ken
I used 4.7k ones on my normal MS v3 for the rx7 because I had some problems with 1k ones on a friend's car, but most people are fine with 1k.
Ken
#29
Quiet Member
iTrader: (1)
Join Date: Aug 2008
Location: halifax
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Microsquirt Ignition Input Capture signal
Excelent That is the info i was looking for
Here is a question i have not seen anybody ask so i'm going to mention it.
According to the microsquirt manual, due to an extra transistor in the VR circuits the setting for "Ignition Input Capture" should be reversed from any MS2 documentation you are following. Has anybody done this?
I have not seen this discussed out side the manual so I figured it was worth bringing up even if the maunal is pritty clear about it.
Here is a question i have not seen anybody ask so i'm going to mention it.
According to the microsquirt manual, due to an extra transistor in the VR circuits the setting for "Ignition Input Capture" should be reversed from any MS2 documentation you are following. Has anybody done this?
I have not seen this discussed out side the manual so I figured it was worth bringing up even if the maunal is pritty clear about it.
Thread
Thread Starter
Forum
Replies
Last Post