Im running a ms2 3.0 I had it in the car for 8mo i came home washed the car and it then wouldnt start at all. I reloaded the s19 then sent the tune i had and then it was ok untill i turn it off and back on again the bottom of mrgatune says conf error. Did my ms2 take a crap I thought it was my laptop but does the same with another one. What does conf error mean? how do I fix this?

 

What is the error? Use hyperterminal to connect to the MS, then power-cycle it. It should tell you what it doesn't like.

Ken

 

I dont see anything called hyperterminal in not to good with computers. I have reflashed the ecu befor than sent the tune i had and worked good. I went through review more and entered all the values then when i turn it off and back on i get maxed rpm and conf error. Im not sure if thats any help to diagnose problem. thanks for any help

 

What tuning software are you using? TunerStudio or MegaTune?

Ken

 

Im running megatune 2.1.1

Anybody know how I can get megatune to tell me what in my configuration is causing me to have this problem?

 

There should be a miniterminal option somewhere in the tools menu I believe. You can turn that on and power cycle the MS to see the error.

Ken

 

Wow it told me staging cannot be the same. I had the first setting on map for the longest time and when i left work i set it to map and rpm then when i got home and cycled the key it quit working so now when i turn off rpm as the second trigger its fine must be a wierd bug. Seen this before?

 

It's not a bug. You can't have the primary and secondary staging triggers the same. It only checks for conflicts on boot so it won't notice until you power cycle.

Ken

 

I dont see how my settings are the same. I just wanted the secondarys to come on above 120kpa and 3k rpm the manual explains it as the secondarys wont come on till both triggers are satisfied. how is it figureing they are the same?

Would settong it to "OR" make it do what im wanting

 

BTW, there is no megatune 2.1.1

I'm assuming that's the firmware revision that you are running.

Please post your msq, I'll take a look.

Ken