Teaser, hot or not?
#5
Full Member
Thread Starter
iTrader: (2)
Join Date: Oct 2007
Location: Nor cal
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
Yes I know wingless for now....I am saving up for a 99 spec, give it a couple more months
Along with that I will be putting on a rear apron and some nice craftsquare mirrors
Along with that I will be putting on a rear apron and some nice craftsquare mirrors
Trending Topics
#16
Full Member
Thread Starter
iTrader: (2)
Join Date: Oct 2007
Location: Nor cal
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
acctually it is burnout sides but their streched and molded to fit the body.
btw, the wheels that are on it are 22 offset 19x10(rear) 19x8.5 (front) but it would look better with 1/4in spacers i know.
thanks for all the comments!
btw, the wheels that are on it are 22 offset 19x10(rear) 19x8.5 (front) but it would look better with 1/4in spacers i know.
thanks for all the comments!
#21
iRussian
iTrader: (3)
Join Date: Oct 2006
Location: midwest IL, USA
Posts: 947
Likes: 0
Received 0 Likes
on
0 Posts
May I suggest getting those new BOSCH icon wiper blades? ON older cars, I notice that the el cheapo looking wiper arms and blades distract me from the fine lines of the car itself, especially after driving a mono-wiper w202. The blades will make the car look 10000 times better!
Overall through, it looks like some good effort and high quality work has been poured into this ride, so lets keep it shiny side up, ok?
EDIT: As far as the rims go, I know it's too common to use the Enkei RPF-1 wheels, but how about some polished NT03+M or RP03's? The Amemiya cars feature those rims, and they look SEXY!
Overall through, it looks like some good effort and high quality work has been poured into this ride, so lets keep it shiny side up, ok?
EDIT: As far as the rims go, I know it's too common to use the Enkei RPF-1 wheels, but how about some polished NT03+M or RP03's? The Amemiya cars feature those rims, and they look SEXY!
#24
Full Member
Thread Starter
iTrader: (2)
Join Date: Oct 2007
Location: Nor cal
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
I just dont have the funds right now to dump more money in.
Btw this was the last Car built by Chuck at Rotary Extreme, spent more than 20grand into the motor and I am now debating on wether I should sell it....
Thanks for all the comments.
#25
John Dillinger
iTrader: (2)
Join Date: Sep 2006
Location: 702
Posts: 1,515
Likes: 0
Received 0 Likes
on
0 Posts
here you go.
https://www.rx7club.com/shineautoproject-161/fd3s-low-profile-spoiler-its-about-freakin-time-725673/
where in cali are u?
https://www.rx7club.com/shineautoproject-161/fd3s-low-profile-spoiler-its-about-freakin-time-725673/
where in cali are u?
Thread
Thread Starter
Forum
Replies
Last Post