Ok, the seats are in. They need a little bit of adjusting and fabrication of 1 set of new ones but these fit perfectly. The seats are sparco Corsa's The custom made brackets cant be adjusted, but thats no problem for me, as Im th only driver in the car. Some pics will be up tomorrow with the fitment of the prelimenary brackets. Within the next week I will make a last set of brackets which are the endproduct. If Any of you guys is interested??????

Im 6'5 and around 220 The seats are positioned very low and about 1" from the rear tubing under/ in front of the bins.

These will bolt up onto all the Sparco sidemount seats.

 

new pics of the Sparco Corsa seat install
https://www.rx7club.com/showthread.p...=1#post4471210

 

Okay I've got a question, I want to sand down my entire dash (87 FC) and get a nice smooth black paint job on it. The dash has a bit of a pattern on it thou, would I still follow the same procedures? Sand prime sand paint sand etc...?

 

Hmmm. Thats a difficult one. Is the dashboard made out of hard plastic ?

If yes, than I think there is no problem. Than you can sand it down and paint it. If its soft material than I dont think it can be done due to cracking.

 

I have a feeling it may be too soft, you've never seen a base FC dash?

 

have seen it, but cant remember it.....

 

here