Haltech Wiring my FC coils for my swap
#1
Wiring my FC coils for my swap
I bought my E8 off of Jacob Cartmill and he was using the exact same engine setup as me (Im doing a REW swap in my FC). His, however, was wired in his FD.
I have the wiring of the Haltech to the FC coils like this:
CAR Haltech
Pink Light green(ign 1)
Pink White/black(ign2)
White Green/black (aux)
Not sure if that's correct, if it is, great!
But my main concern is setting up the ignition in Halwin.
The ecu already has a good tune (will need a quick redo due to my location) so would I need to change anything to make the FC coils fire up since the ecu was previously running on the FD ignition?
I have the wiring of the Haltech to the FC coils like this:
CAR Haltech
Pink Light green(ign 1)
Pink White/black(ign2)
White Green/black (aux)
Not sure if that's correct, if it is, great!
But my main concern is setting up the ignition in Halwin.
The ecu already has a good tune (will need a quick redo due to my location) so would I need to change anything to make the FC coils fire up since the ecu was previously running on the FD ignition?
Thread
Thread Starter
Forum
Replies
Last Post
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM