Hey guys, I am having a hard time figuring out why my secondary injectors are not coming on. I have searched the site but cannot find anythng that has helped me.

Here is some info:
850ccx2 primary
1680ccx2 secondary

Injection setup is:
Injecors enabled
Batch mode
Staged injection enbled with staging bar at 13 and in common mode
Ignition devide 2
Fuel Scale 100%
Injection angel end of injection
Have not done anything with trims everything is at zero.
I am using injector outputs 1,2,3,4 with 1,2 primary and 3,4 on secondary.

Am I missing something here??? I have tried to move staging bar up and down but as soon as the car reaches whatever staging point I have it set at, it goes very lean and falls on its face. The injectors were working fine until the ecu change. I am hoping that it is not the drivers What do you guys think?

Thanks in advance

Roky

 

Anybody have any ideas??

I took the injectors out and had them tested, everything check out there. I have 12v at all the injector clips via red wire, and checked continuity from ecu connector pins to each injector clips and everything checks out there also. Is there anything I am forgetting or have not checked, or do I have something set up wrong in the e11?

When the injector drivers go out in the ecu, how do they go out typically? In pairs, groups or just one at a time?

Thanks

 

Change the injection mode to sequential.

 

Wow do I feel dumb!!! I read in the manual that it needed to be setup in sequential, but was advised differently. I guess they wright manuals for us for a reason.

Thank you for the help ludwig.