Haltech Quick E6K ??
#1
Part out my Car
Thread Starter
Join Date: Feb 2002
Location: Denver, Colorado
Posts: 1,762
Likes: 0
Received 0 Likes
on
0 Posts
Quick E6K ??
Im trying to trace down my Ignition spark problem and i was wondering if was huntinga non exsistant problem. Will the haltech all the spark if the UIM is off and it dosent have allow the values like TPS, Air Temp, MAP vaccum, ect? I tihnk i might be chasing my own tail.
Thanks
Marc
Thanks
Marc
#3
Lives on the Forum
it should... i know i had a problem in an rx3 using TII coils that could no get a spark but it was because they were not grounded. basicly started wiring one night and was just trying to get the car to start to drive it into a different parking spot instead of pushing it and didnt mount the coils. once they were ground, fired right up.
maybe this will be relevent to your problem marc?
maybe this will be relevent to your problem marc?
#5
Part out my Car
Thread Starter
Join Date: Feb 2002
Location: Denver, Colorado
Posts: 1,762
Likes: 0
Received 0 Likes
on
0 Posts
Well i think i figured it out, 3 plug wires were bad seem kind of odd to me but im waiting on some new one and ill let you know if it fixes it. By the way the car dose spark with the UIM off.
#7
Part out my Car
Thread Starter
Join Date: Feb 2002
Location: Denver, Colorado
Posts: 1,762
Likes: 0
Received 0 Likes
on
0 Posts
No it was the wires i was puzzled also, i was testing from the coil to the wire and i had spark at the coil but not on the other end of 3 of them, got some new ones and it firing fine, i have spark on all the plugs, not sure how 3 wires go bad but its me so its not hard to expect.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM