Haltech peak and hold mode staged injection (E11/E8)
#1
registered user
Thread Starter
iTrader: (1)
Join Date: Jan 2006
Location: San Diego
Posts: 2,469
Likes: 0
Received 0 Likes
on
0 Posts
peak and hold mode staged injection (E11/E8)
I want to re tune my current map for peak and hold, with 550-1680 injectors. currently I am running in common mode with the staging bar at 1.2 not (just barley) untill after 6K rpm do I hit 90% Duty cycle.
Anyways without doing a hell of allot of trail and error, what should I set the staged disenrichment at for this injector combo?
I was thinking very high, like 5MS or so. Assuiming that this is similar to staged injection on the microtech only reduceing by a set number of MS rather than increasing by a set percentage before staging.
I created an excell spread sheet which should calculate the new values for all load points based upon the last bar before staging occurs, and in theory at least give me about the same amount of fuel as I previously had for all those load points. In reality I am just hoping for a starting point.
Well any insight is appreciated.
Anyways without doing a hell of allot of trail and error, what should I set the staged disenrichment at for this injector combo?
I was thinking very high, like 5MS or so. Assuiming that this is similar to staged injection on the microtech only reduceing by a set number of MS rather than increasing by a set percentage before staging.
I created an excell spread sheet which should calculate the new values for all load points based upon the last bar before staging occurs, and in theory at least give me about the same amount of fuel as I previously had for all those load points. In reality I am just hoping for a starting point.
Well any insight is appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM