Haltech just a note on the IAT and CT sensor clips.
#1
just a note on the IAT and CT sensor clips.
the wires go through the clips first, then you crimp on the connectors. nowhere is this said in the manual, and these two bastard connectors are the only ones like this.
no fault to haltech. its gm's fault. they are bastards. However, i feel its kinda necessary to mention this as this will ruin someones day pretty quickly.
yeah, my haltech install has come to a screeching halt now because of this crap.
no fault to haltech. its gm's fault. they are bastards. However, i feel its kinda necessary to mention this as this will ruin someones day pretty quickly.
yeah, my haltech install has come to a screeching halt now because of this crap.
#2
www.lms-efi.com
iTrader: (27)
Actually, blame Delphi. They have a love affair with pull-to-seat connectors. We now have a push-to-seat version of the IAT and CLT connectors. I'll check to see if we have any spare pull-to-seat pins. If we do, I'll send them out to you.
As a tip, always check the pins before you crimp them. If they have a locking tab on them, the direct it faces will give away what type it is. If there is no locking tab, it's generally push-to-seat.
As a tip, always check the pins before you crimp them. If they have a locking tab on them, the direct it faces will give away what type it is. If there is no locking tab, it's generally push-to-seat.
#5
Uncontrollable drifter
iTrader: (1)
Haltech actually did good with this guide http://www.haltech.com/wp-content/up...ECTORS-ALL.pdf
Thread
Thread Starter
Forum
Replies
Last Post
msilvia
3rd Generation Specific (1993-2002)
15
09-11-15 12:13 PM