General Rotary Tech Support Use this forum for tech questions not specific to a certain model year

won't start flooded ???

Thread Tools
 
Search this Thread
 
Old 01-10-04, 02:56 PM
  #1  
Junior Member

Thread Starter
 
sj_rx7nut's Avatar
 
Join Date: Dec 2003
Location: New Jersey
Posts: 49
Likes: 0
Received 0 Likes on 0 Posts
won't start flooded ???

My '91 convt. won't start. It was running great until it got cold today (15 degrees). I kept trying to turn it over and I think I flooded it.

I have a fuel shutoff switch, if I turn it off and let it sit until tomorrow will it un-flood on its own or do I have to do something ?
Old 01-10-04, 03:07 PM
  #2  
it WILL run

 
wwilliam54's Avatar
 
Join Date: Dec 2002
Location: Raleigh,MS
Posts: 2,017
Likes: 0
Received 0 Likes on 0 Posts
you have to put the gas pedal to the floor and crank it for several seconds

it wont unflood by itself
Old 01-10-04, 03:11 PM
  #3  
Junior Member

Thread Starter
 
sj_rx7nut's Avatar
 
Join Date: Dec 2003
Location: New Jersey
Posts: 49
Likes: 0
Received 0 Likes on 0 Posts
Should I leave the fuel switch off until I get it to turn over ?
Old 01-10-04, 05:00 PM
  #4  
it WILL run

 
wwilliam54's Avatar
 
Join Date: Dec 2002
Location: Raleigh,MS
Posts: 2,017
Likes: 0
Received 0 Likes on 0 Posts
yuh
Old 01-11-04, 01:33 PM
  #5  
Junior Member

Thread Starter
 
sj_rx7nut's Avatar
 
Join Date: Dec 2003
Location: New Jersey
Posts: 49
Likes: 0
Received 0 Likes on 0 Posts
I recharged the battery, pulled the plugs and cleaned them (top plugs were wet with gas). I put everthing back held the pedal to the floor and it still will not start.

The plugs had some build up on them, I cleaned them best I could with a towel.

It cranks, it just doesn't start. I'm off to pepboydsd to buy new plugs.

Any other suggestions. Could I have bigger problems then a flooded car ?
Old 01-11-04, 02:09 PM
  #6  
Junior Member

Thread Starter
 
sj_rx7nut's Avatar
 
Join Date: Dec 2003
Location: New Jersey
Posts: 49
Likes: 0
Received 0 Likes on 0 Posts
I waited and got it started, but then one of the belts started to smoke. The outer most belt heated up on the cooling fan pully. I don't the cooling fan pulling was turning. Is it suppose to ?

please help
Old 01-11-04, 02:09 PM
  #7  
Junior Member

Thread Starter
 
sj_rx7nut's Avatar
 
Join Date: Dec 2003
Location: New Jersey
Posts: 49
Likes: 0
Received 0 Likes on 0 Posts
I waited and got it started, but then one of the belts started to smoke. The outer most belt heated up on the cooling fan pully. I don't the cooling fan pulling was turning. Is it suppose to ?

please help
Old 01-11-04, 03:37 PM
  #8  
it WILL run

 
wwilliam54's Avatar
 
Join Date: Dec 2002
Location: Raleigh,MS
Posts: 2,017
Likes: 0
Received 0 Likes on 0 Posts
if the belt smoked then the pulley might be locked up
you should be able to turn all the pullies by hand
Old 01-11-04, 03:59 PM
  #9  
Junior Member

Thread Starter
 
sj_rx7nut's Avatar
 
Join Date: Dec 2003
Location: New Jersey
Posts: 49
Likes: 0
Received 0 Likes on 0 Posts
Someone said water pump might be seized.

Is replacing the water pump a big job ? Is it an expensive part ?
Old 01-11-04, 04:33 PM
  #10  
it WILL run

 
wwilliam54's Avatar
 
Join Date: Dec 2002
Location: Raleigh,MS
Posts: 2,017
Likes: 0
Received 0 Likes on 0 Posts
ive not seen a s5, but on a fb its pretty simple, it shouldnt be much different, pretty strait foward

get a http://www.victoriabritish.com/ catalouge
has most of the part you need, but a a tad pricy
also check napa they tend to be pretty cheap for me

and get a haynes manuel

edit: i looked in VB they dont have a pump, napa should and it shouldnt be expensive
Old 01-11-04, 08:21 PM
  #11  
Junior Member

Thread Starter
 
sj_rx7nut's Avatar
 
Join Date: Dec 2003
Location: New Jersey
Posts: 49
Likes: 0
Received 0 Likes on 0 Posts
I think I found the problem, I got the car running, but it is leaking coolant like crazy. I took the rad cap off and there is ice in the spout.

I'm guessing the guy I brought the car from didn't put enought anti-freeze in. It was 7 degrees here yesterday.

I ran the car for about 10 minutes, when it started to heat up I shut it down. Do you think the ice caused any major damage ?
Old 01-12-04, 05:56 PM
  #12  
it WILL run

 
wwilliam54's Avatar
 
Join Date: Dec 2002
Location: Raleigh,MS
Posts: 2,017
Likes: 0
Received 0 Likes on 0 Posts
hope not better look for cracks
Old 01-12-04, 07:39 PM
  #13  
Junior Member

Thread Starter
 
sj_rx7nut's Avatar
 
Join Date: Dec 2003
Location: New Jersey
Posts: 49
Likes: 0
Received 0 Likes on 0 Posts
Its leaking at the front of the car, looks like below the radiator, I just can't see anything. The car starts fine so I'm hoping theres no major engine damage.

Does the rx7 have a freeze plug designed to pop if this situation happens ?

Do I remove both drain plugs (on rad and on engine block) to drain the system ?

Any suggestions on where to get a radiator, mazdatrix has one for $233.

Thanks for your responses.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
1993fd3sracer1
3rd Generation Specific (1993-2002)
29
10-13-15 01:57 PM
1993fd3sracer1
1st Generation Specific (1979-1985)
20
09-07-15 11:50 AM
PhillyFC
General Rotary Tech Support
9
08-21-15 06:36 PM
Im faster
General Rotary Tech Support
4
08-19-15 02:57 PM



Quick Reply: won't start flooded ???



All times are GMT -5. The time now is 10:48 PM.