Are my rotors f***ed?
#6
KILL KILL KILL
Thread Starter
iTrader: (-1)
Join Date: Sep 2006
Location: NAS Whidbey Island, WA
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
Maac apparently you didn't read the post I already cleaned them in a solvent solution thanks though and I want a few more opinions before I use these but I'm leaning towards using them
Trending Topics
#8
Its hard to tell someone if they should use something or not, just by looking at a picture.. The only way to really tell if something is useable, is to measure, measure and then measure some more..
As stated above, get yourself some quality measuring equipment and go ahead. Download the FSM (search around here), it states all the tolerances and measurements you need.
There is reason using parts, just because the look good, if they are way out of spec..
As stated above, get yourself some quality measuring equipment and go ahead. Download the FSM (search around here), it states all the tolerances and measurements you need.
There is reason using parts, just because the look good, if they are way out of spec..
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
20B Forum
9
09-22-15 07:39 PM