so i soaked my rotors in simple green 1:10 water over night and this is what i got, are they totally screwed or are the usable?

 

rotors are okay to use

 

use a rag and some gasoline and scrubb it off.

 

Bump

 

I sent pics to your e-mail. Let me know what you think.

 

Maac apparently you didn't read the post I already cleaned them in a solvent solution thanks though and I want a few more opinions before I use these but I'm leaning towards using them

 

Wd-40.

 

Its hard to tell someone if they should use something or not, just by looking at a picture.. The only way to really tell if something is useable, is to measure, measure and then measure some more..

As stated above, get yourself some quality measuring equipment and go ahead. Download the FSM (search around here), it states all the tolerances and measurements you need.

There is reason using parts, just because the look good, if they are way out of spec..