How do I fix my hyper turn signal?
#1
~~~~~~~~~~~~~~~~~~~~~~~
Thread Starter
Join Date: May 2001
Location: Pittsburgh, PA
Posts: 1,594
Likes: 0
Received 0 Likes
on
0 Posts
How do I fix my hyper turn signal?
I have the damn hyper blinking turn signal. It is only the right turn that does it. I removed the relay from the CPU and took some digital photos hoping somebody here might know how to fix it. I am comfortable with replacing any part of the circuit board but I don't know which part is bad. I'd rather not spend $60 to get a new one. Here they are; any help would be greatly appreciated!
91 vert
91 vert
#3
~~~~~~~~~~~~~~~~~~~~~~~
Thread Starter
Join Date: May 2001
Location: Pittsburgh, PA
Posts: 1,594
Likes: 0
Received 0 Likes
on
0 Posts
Not the ECU; the CPU. This is the flashing unit. Those two large pieces in the middle are what flap back and forth to make the light blink. I hooked it up and just layed it on the floor mat and watched it move. One of them would move nice and slow right in rythmn with the blinker but the other was wild and jumped around way to fast.
#6
Senior Member
Join Date: Mar 2002
Location: HK/Toronto
Posts: 376
Likes: 0
Received 0 Likes
on
0 Posts
In most cars, the front and rear turn signals shares the same current and when one goes out the reminding one will get all the power so that will flash super fast. Just replace the one the old blub and things will be back to normal.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 11:02 PM