i started to teardown this s4 Tii block. got it from a goood friend of mine (tofuball).
engine rotated by hand but rear rotor sounded a little low compared to front on compression.

UNKOWN MILEAGE & CONIDITION OF MOTOR PRIOR TO DISASSEMBLY

as i was tearing the motor down i notice the housings were black. (possible overheat condition?)



I also notice like blueish spots or hues on the intake plate











REAR IRON


DEEP GROOVE ON REAR HOUSING?




MORE REAR ROTOR HOUSING PICS





Rear Rotor Bearing HAS BLUE SPOTS AND SCRATCHES





ESHAFT WHERE BEARING RODE ON




I should be conituing the breakdown tomorrow with more pics to come.

 

Yep, it's been too hot. Also looks like the oil was too hot and not changed often enough. I would pass on that housing, bearings need replaced and the e-shaft is questionable. Make sure you spec the irons for warpage. If the other housing isn't grooved, it may be reuseabe.

 

ok i will keep dissassembling, please disregard the bridgeport iron, was put there by mistake.

 

Awesome. I'm glad that engine isnt rusted from sitting for so long

 

That looks like the one I did for SlammedBlk7.

B

 

ya sorry BDC, i use it as a wallpaper and put it up there by mistake ha.
what do u think of the motor?