Compression tester
#1
Full Member
Thread Starter
Join Date: Aug 2004
Location: bremerton
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
Compression tester
Compression tester what is the difference between a standard piston and rotory. WHere can i get a rotary one and how do i test it with a standard piston compression tester. Thanks Rob
#2
Weird Cat Man
If you have used a standard piston type and know about that one.... then check out my page on my rotary one...
http://www.zeroglabs.com/rx7/compression.htm
You should be able to figure it out I got mine from a rotary recycling place online.
You can not do a "real" test with a piston one, but you can sometimes get a ballpark idea by holding the relief valve open or removing it from the piston engine model and watching for even bounces of the needle
http://www.zeroglabs.com/rx7/compression.htm
You should be able to figure it out I got mine from a rotary recycling place online.
You can not do a "real" test with a piston one, but you can sometimes get a ballpark idea by holding the relief valve open or removing it from the piston engine model and watching for even bounces of the needle
#3
Racing Rotary Since 1983
iTrader: (6)
get a simple compression tester
remove the schroeder valve.
remove bottom sparkplugs from a warm engine.
pull the fuel pump fuse (in the fuse box near the drivers left foot.) yellow 20 A.
pull plug wires
floor throttle
crank engine
videotape compression gauge close up
play video back on tv and record each power impulse.
cross your fingers.
howard coleman
remove the schroeder valve.
remove bottom sparkplugs from a warm engine.
pull the fuel pump fuse (in the fuse box near the drivers left foot.) yellow 20 A.
pull plug wires
floor throttle
crank engine
videotape compression gauge close up
play video back on tv and record each power impulse.
cross your fingers.
howard coleman
Thread
Thread Starter
Forum
Replies
Last Post