48 IDA on stock port
Never on a stock port engine but that won't matter. The IDA can be tuned for everything from stock ports to whatever port you dare run. The venturi size that comes with the IDA is a good place to start (IIRC 37mm I forget) for your 12A on the street. It might be a little touchy just off idle.
The only con, beside that fact its a carb, is no choke. With a little foot work for about a minute this can be dealt with though.
The only con, beside that fact its a carb, is no choke. With a little foot work for about a minute this can be dealt with though.
Thread Starter
Senior Member
Joined: Jun 2008
Posts: 253
Likes: 0
From: Toronto
Never on a stock port engine but that won't matter. The IDA can be tuned for everything from stock ports to whatever port you dare run. The venturi size that comes with the IDA is a good place to start (IIRC 37mm I forget) for your 12A on the street. It might be a little touchy just off idle.
The only con, beside that fact its a carb, is no choke. With a little foot work for about a minute this can be dealt with though.
The only con, beside that fact its a carb, is no choke. With a little foot work for about a minute this can be dealt with though.
What do you mean by little foot work? it runs bad off cold start untill running temp is achived?
i figured it could be tuned if neccesary i hope it makes a nice difference
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM
msilvia
3rd Generation Specific (1993-2002)
28
Apr 14, 2016 12:58 PM
