ImageShack.us

here my setup. sorry its dirty from the mud and track days ]. i have it the lift so happen to take pics
i believe subaru impreza tie rods are interchangable 93-05. its been awhile. so it fits perfect in the rack and the outer fits perfect with s13 outers.
i only done this as my friend did a mod with extension of lower ball joints.
thanks. sorry been busy.

any questions lmk. or more pics lmk.

 

So in this picture you have '93-'05 Subaru Impreza inner tie rods and factory S13 outer tie rods. That is an extended ball joint as well? Kind of hard to see.

How's the bumpsteer? When on the ground, are the rod and the joint angles still pretty good?

Thanks,

Andrew

 

Yes the ball joint is extended.
My spindles are still stock.
At full lock nothing hits I use a 1 inch spacer so the tie rods are long enough to where the rack max out and have plenty of room.
The rod angles are still decent I would say but my car is really low and I haven't corrected much yet. I have to remake the ball joints extension by maybe half an inch so less of an angle for better correction. And less adjust for neg camber. As the adjust right now is -2 to -8 camber in
front.
I'll take a pic on the ground
Did you want to see the ball joint mod?

 

????

 

yes!
killin it!
baby yellow llaama!

 

WOW! If that is the old red car, that is quite a change! And it looks gooooood

 

wow that **** is yellow

 

god i don't even need to post anything from now on.
you are always on point with everything i want to say! hahaha stole the words right outta my mouth.

 

i saw a picture the night this was being a painted and thought wow thats gonna look like ****... WOW i was wrong!! looks sick man

 

Thanks for the info. might give this a try.

 

More pictures ilia. **** looks damn good.

 

looks like FD CYM, maybe a little bit more yellow and less banana-ish

 

 

do i need to beat this?^

 

tale the wheels off and just lay the chassis on the ground?

 

actually no, straight struts laying on 18's with no tires. it was still towable... barely...

 

everyone loses.

 

Buckey: I thought you car look good 2ins higher....now it looks even better on the ground! Make some RCA's and keep it that low.

 

First rx7 n/a rollin on 14s son!!!

 

the halfshafts are locked on the upper diff mounts because of their angle up lol

fuuuuuuu

 

lol...

my rear over fenders have 2 inches cut out of the arch and the front is cut a 1/4 inch...

Tucking in the back but not up front.

but i dont have pics so i'll stfu

 

on 18s the car wont roll if it's at this height.

 

most deff

 

ilia and jtp's cars make me want a fc superrr bad.

 

not low enough