thewird's 20B Track Beast Project Finally Started :D
09-12-12, 10:28 PM
#51
. I liked what I was seeing there. I wanted to come and say hi to ask about your setup but was busy doing the final tweaks on Jimmy's tune.thewird
09-13-12, 06:42 PM
#52
Andrew.
09-14-12, 12:04 AM
#54
Cleaned up the rotors and put the side seals and corner seals in labeled boxes as I'm thinking about reusing them (after checking clearance) since there in such good shape. Bad news is I have to change all the rotor bearings. Well one is in good shape but since I'm changing the other 2, I'm changing them all. Also all 3 stationary gear bearings need to be changed and the 20b center stationary gear needs to be changed as there is noticeable wear on the gear teeth... I think I'm going to run 20w50 in this motor (in addition to the extra oil mods) just as added precaution, it seems that oiling is significantly more important on the 20b then the 13b, even for a stock one. The 13b never cared what oil I put in it LOL.
thewird
thewird
09-19-12, 02:15 PM
#58
4th string e-armchair QB
iTrader: (11)
Join Date: May 2005
Location: North Bay, Ontario
Posts: 2,745
Likes: 0
Received 0 Likes
on
0 Posts
I have 2 mazda racing competition rotor bearings if you're interested! You doing any side clearancing on those rotors, and are you using extra dowels or a few oversized studs?
09-19-12, 07:52 PM
#64
Care to elaberate...?
you sent him maps, he did logs, and sent back, then you adjusted..?
I might (if your willing) send you a question or two about learning to tune from scratch (through the PFC group) because of how good you have become and to learn from, basically scratch... which is exactly what I'm just starting to do..
BTW, got the WB in, put it in the stock port like you suggested... so far its working good...
J.
09-21-12, 05:29 AM
#65
Care to elaberate...?
you sent him maps, he did logs, and sent back, then you adjusted..?
I might (if your willing) send you a question or two about learning to tune from scratch (through the PFC group) because of how good you have become and to learn from, basically scratch... which is exactly what I'm just starting to do..
BTW, got the WB in, put it in the stock port like you suggested... so far its working good...
J.
you sent him maps, he did logs, and sent back, then you adjusted..?
I might (if your willing) send you a question or two about learning to tune from scratch (through the PFC group) because of how good you have become and to learn from, basically scratch... which is exactly what I'm just starting to do..
BTW, got the WB in, put it in the stock port like you suggested... so far its working good...
J.
Got my coils I'm going to use for the 20b
thewird
09-25-12, 07:38 AM
#72
4th string e-armchair QB
iTrader: (11)
Join Date: May 2005
Location: North Bay, Ontario
Posts: 2,745
Likes: 0
Received 0 Likes
on
0 Posts
They must have gone up, last time I grabbed some they were over $10 cheaper/plug. Either way it's your money, I was just curious. Project will be BA, I just hope you finally cave one of these days and build a cage!
. Added some colors so I can fap to it when needed LOL. Ready to make some torque at high boost reliably 
