is there anyone in/around hamilton whos willing to help me get my rx7 started?

Zeeshan

 

What's happening?
Dead battery? Starter? Flooded?
Be more specific about what you tried to do and you might get a nibble of an answer.

 

^^ agree

 

Wait a minute.....I was in Hamilton today working on an FC......are you Kyles buddy?

 

i got it to start, but it ran like crap. sound like a bridgeported rx7. let it warm up and then did a compression test. pretty sure the apex seals are seized. im losing compression pulses on the rear rotor.

i started it back up and reved back and forth from 2000rpm to 6000rpm and let the engine idle. the car started sounding much better. no more bridgeported rx7 idle. sounded like the seals freed up.

tried to drive down the block and and floored it to 4000-5000rpm and bam, car started running like a bridgeported motor again. drove it back home. did the compression test, same results as before.

i'm pulling engine this week and just going to rebuild the engine before there is catastrophic damage. it's got 100,000 km on it.

 

I can help but don't know much about rebuilds