Eric RX7 Bridge Port Build
03-05-12, 11:22 PM
#1
Eric RX7 Bridge Port Build
Hi, I am making this thread for a build I am doing on my friend Erics car. He dropped an aluminum washer and tried everything to get it and decided to open up the motor and have it bridge ported. I started the motor today March 5 2012 and found all the irons, rotor housings, rotors, e-shaft to be in great condition. After disassemble he picked up the pieces and is getting them bridge ported. When the pieces return I am going to thoroughly clean, paint, and rebuild the motor to spec.
Thread
Thread Starter
Forum
Replies
Last Post
Azevedo
Other Engine Conversions - non V-8
26
03-01-19 09:19 PM
