THE TECH's 94 CW
The following users liked this post:
THE TECH (08-15-17)
The following users liked this post:
THE TECH (08-16-17)
The following users liked this post:
THE TECH (08-16-17)
The following users liked this post:
THE TECH (08-16-17)
you sir are a lucky one!!
08-18-17, 09:34 PM
#188
08-21-17, 11:14 AM
#191
So we installed the Exedy this weekend. What a pain. Exedy decided they would not include the correct alignment tool without telling us. We tried installing the transmission and clutch 5 times before I decided to measure the included tool against the input shaft on the transmission. The tool they send is obviously made for use with a single disk clutch and not the multi disc ones. After finally figuring that out, and we modified it, we got the trans to go right back in. What a huge waste of time. The clutch pedal is definitely heavier than I was expecting on a multi plate unit so that was also a disappointment.
Also we installed the Amuse R1 exhaust. Bolted up perfectly like every Amuse product does. No drama!
Also we installed the Amuse R1 exhaust. Bolted up perfectly like every Amuse product does. No drama!
08-21-17, 01:26 PM
#192
RX-7 Bad Ass
iTrader: (55)
On the clutch alignment tool, most all of them I've come across are too long, the tip is really long. Cutting about a half inch off the tip makes it work way better. I think they just use a generic mold and send it. This isn't an Exedy thing, this is EVERY clutch I've ever come across.
The SMB cat is a great way to go, I've had mine for probably 10 years. No air pump, running it hard, never have had an issue (knock on wood). Flows great and really knocks the stink down.
Dale
The SMB cat is a great way to go, I've had mine for probably 10 years. No air pump, running it hard, never have had an issue (knock on wood). Flows great and really knocks the stink down.
Dale
08-21-17, 02:00 PM
#193
On the clutch alignment tool, most all of them I've come across are too long, the tip is really long. Cutting about a half inch off the tip makes it work way better. I think they just use a generic mold and send it. This isn't an Exedy thing, this is EVERY clutch I've ever come across.
The SMB cat is a great way to go, I've had mine for probably 10 years. No air pump, running it hard, never have had an issue (knock on wood). Flows great and really knocks the stink down.
Dale
The SMB cat is a great way to go, I've had mine for probably 10 years. No air pump, running it hard, never have had an issue (knock on wood). Flows great and really knocks the stink down.
Dale
08-27-17, 09:16 AM
#197
Banned. I got OWNED!!!
this is an awesome build to witness.. that miracle bart setup is gorgeous.
keep it up bro it looks super awesome and I bet you have a few more ideas in store
keep it up bro it looks super awesome and I bet you have a few more ideas in store
The following users liked this post:
THE TECH (08-28-17)
08-28-17, 04:07 PM
#200
Good progress! I'm caught up and you have been busy. Got any pics of the cat back on the car? I've always loved that exhaust. I really wanted one for the LS3 swapped FD I had. I just thought it might be too loud on a rotary car. Might not be seeing you are running a cat.