I'm about to install a 100% meth system on my FD. I will be using Howard Colemans optimum location. I have the baseplate for my pump cut, and am now making the brakets.

I just ordered a 1 gallon fuel cell (with foam) to go in the back of the car, maybe even in the driver side bin , (my batter is in the passenger side).

Since the line will be running along the bottom of my car, I want to use braided stainless line, where is the best place to purchase this?

Howard, or anyone else with this setup - what size line do you use, and roughly how long was the section that ran from the pump to the engine bay?

My fuel cell has to outputs, and one vent, how do I mount a level sensor in it? the outputs are at the very bottom of the side of the tank, so I would need a sensor that protuded upwards from one somehow.

I'll be using two 600ml/min nozzles, and the controller is a progressive controller from Snow Performance, not quite HD, but still progressive.

 

I also noticed in a comment from Howard that he used the Nylon line instead of braided stainless on his new setup. Is this true for the long line that runs the length of the bottom of the car as well?

 

-3AN teflon core, stainless-steel braided line with brass ends.

B

 

Thanks, I have a ton of line left over from a nitrous kit, is there any way to tell if its teflon core? Or is braided line usually teflon core? Its definitely long enough so it would be sweet if I could use it.

 

Any thought on the line? Also, I was looking at my controller, and the highest starting poing is only 8psi. I guess I should have looked more closely, I had assumed that both dials were the same, the full flow dial goes up to 25psi.

I hadn't really intended on using meth at such low boost levels, I only have a 1 gallon tank, and while I know the injection levels will be low at the low psi i was hoping to have injection start at 14psi or so. What does everyone else use?