creature546

iTrader: (1)

I looked in the FSM but can seem to find it..

I am looking for the pin outs of the white and blue plugs down near the ECU plugs of the engine harness. mainly the thick black/green wire and the thick black/red wire. but know all the wires would be nice...



Also does anyone know where the coolant level disconnect pins to ? i have a plug but the wire is broken in the harness and cant seem to find a end.

Thanks

Seth

Mahjik

iTrader: (1)

You need the wiring diagrams which is different than the FSM:

http://mahjik.homestead.com/files/ho...ng_Diagram.zip

creature546

iTrader: (1)

yeah already have that.....i can seem to find to 2 plugs listed....I am thinking they are one of the common connectors but I am unsure. any ideas?

Seth

Mahjik

iTrader: (1)

Are these plugs off the emissions harness coming from the engine bay, or part of the interior harness that runs behind the dash?

I'm assuming you are having the low coolant buzzer going off? If so, check this thread:

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/coolant-buzzer-problem-862914/

creature546

iTrader: (1)

They are on the emissions harness side. I removed the harness to clean it up and repair anything that was broke....theis wires are the only ones i could not figure out...

As for low coolant buzzer....it only went of when coolant was low. The plus is a black single pin plug with a sold black wire coming from it. It is located right near the OMP plug..

Seth

creature546

iTrader: (1)

Figured out the coolant level disconnect. Still have 2 wires left that i need to know...

wire 1

Blue plug near to ECU plugs. looking at it from the back side push tab facing up it is the black/green wire in the top row all the way to the left.

Wire 2

White plug near the ECU plugs. Looking at it from the back side with the push tab facing up. it is the Black/Red wire in the 2nd row down 3 in from the right

Just need to know what they go to so i can finish the harness up and wrap it back up

Thanks

Seth

Mahjik

iTrader: (1)

X-05 USDM (EM)10PINS

B/G - EGR
Y- 1ST GEAR
BR/B - TPS
BR/W - PRESS SENSOR
B/Y - INJECTOR 12V
W/L - COOLING RELAY
B/W - SOLENOID VALVES
R - 2ND GEAR SWITCH
BR - TRANNY
B/L - EGR

How many pins on that connector?

creature546

iTrader: (1)

14, I am thinking its going to be my water thermoswitch.

Seth