Vacuum lines for aftermarket parts? help?
#1
Full Member
Thread Starter
Join Date: Aug 2005
Location: WI
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
Vacuum lines for aftermarket parts? help?
Hello, i am putting together a 94 rx7 that was torn apart when i got it, i was given all the parts but have had a few troubles finding where everything ends up. what it comes down to is i have 4 open vacuum lines and 4 open 'nipples' but dont know where each one goes.
pic1
pic2
pic3
pic4
pic5
pic6
in pic 1 there is the open nipple
pic 2 has 2 open nipples on the intake manifold
pic 3 shows 2 vacuum lines running through the firewall (there are 3 that go inside the car total that i dont know where they hook into) one is a straight line and the other has a splitter on it.
pic 4 is the BOV
pic 5 shows a manual boost controller
pic 6 is the turbo gauge (has a nipple on back)
in the end i have an open nipple on the back of turbo gauge, 2 on intake , one on BOV, an input and out on turbo boost controller, and last on the greddy pressure sensor.
i do not know where to look for a diagram but im sure many others havedelt with this and this is my first time working on an rx7 so i am clueless. i have tried to look many places for info but came across junk. any help would be tremendous,
thank you.
ps. its a miata converted to rx7 so the engine bay may be setup a little bit differently.
pic1
pic2
pic3
pic4
pic5
pic6
in pic 1 there is the open nipple
pic 2 has 2 open nipples on the intake manifold
pic 3 shows 2 vacuum lines running through the firewall (there are 3 that go inside the car total that i dont know where they hook into) one is a straight line and the other has a splitter on it.
pic 4 is the BOV
pic 5 shows a manual boost controller
pic 6 is the turbo gauge (has a nipple on back)
in the end i have an open nipple on the back of turbo gauge, 2 on intake , one on BOV, an input and out on turbo boost controller, and last on the greddy pressure sensor.
i do not know where to look for a diagram but im sure many others havedelt with this and this is my first time working on an rx7 so i am clueless. i have tried to look many places for info but came across junk. any help would be tremendous,
thank you.
ps. its a miata converted to rx7 so the engine bay may be setup a little bit differently.
#2
I speak Japanglish
http://www.turborx7.com/images/Techn...e_diagram2.jpg
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/faq-3rd-gen-other-useful-links-68640/
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/faq-3rd-gen-other-useful-links-68640/
Last edited by RE Suzuki; 04-07-06 at 02:48 AM.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM