Where should I put the pressure chamber and turbo control solenoid.
I have problem location a decent place to put them. Other than fabricating something. I don't have the ability to fabricate anything at this time.
Any ideas?

Look at the photos...

 

photo1

 

photo2

 

This is the setup me and Mindphrame have. I can't tell by your pic, but don't forget to hookup the Fuel Pressure Regulator solenoid. It's the one that goes on the orange plug.



Look at the engine bay pic in my sig.

 

Jonski,

How do you bolt the pressure tank?
If I put mine there like yours, it would move around.
I am afraid it will vibrate while the engine running, and move somewhere else...

Reza

 

Just like half of my solenoids, I just stuck it in there and left it loose.

 

Does it move around when you drive?
Is it possible that it pinch some vac hoses?

 

I don't think they are moving, but they probably wiggle and move a little bit when turning or going over bridge gaps and stuff. I used the hosetechniques tubing and that stuff will not easily kink.