turbos and wastegate
#1
Rotary Enthusiast
Thread Starter
turbos and wastegate
Took apart my turbos and look at my wastegate and oh no! cracks!!
look like fissures around the wastegate. The wastegate flap was actually only 1/8" covering the hole...is this close enough?
If not, how close is "safe" to the flapper coverage area?
What else can I do other than wastegate porting while the turbos are out?
Wish I had the money to buy BNR turbos while the engine is out!
Anyone want to buy a 2001 Yamaha R1 (8k mi) yosh trs tri-oval full race SS/Ti/CF can...Mikuni 132.5 main jets...?
thanks
look like fissures around the wastegate. The wastegate flap was actually only 1/8" covering the hole...is this close enough?
If not, how close is "safe" to the flapper coverage area?
What else can I do other than wastegate porting while the turbos are out?
Wish I had the money to buy BNR turbos while the engine is out!
Anyone want to buy a 2001 Yamaha R1 (8k mi) yosh trs tri-oval full race SS/Ti/CF can...Mikuni 132.5 main jets...?
thanks
#3
Rotary Enthusiast
Thread Starter
just kidding there "winner"...
300 posts...I know where to post classified
Seriously, you are not THAT stupid are you?
300 posts...I know where to post classified
Seriously, you are not THAT stupid are you?
Last edited by cover8; 01-16-03 at 04:15 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM