Troubleshooting no spark
#1
Full Member
Thread Starter
iTrader: (3)
Join Date: Jan 2013
Location: georgia
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Troubleshooting no spark
I've got no power to any of the plug wires everything else works. Car ran fine and then two days later nothing. Fuel is working according to fuel on the plugs.
Is there a fuse that only effects the ignition? I can't find one on the diagram.
I'm guessing that both coil packs going out is unlikely so i'm thinking it could be the igniter but where is it? Any specific grounds to look for?
I did find a two wire harness with the wires burned off. It's under the manifold from having the sequential system removed and wasn't connected.
powerfc
bnr twins
meth
exhaust
Is there a fuse that only effects the ignition? I can't find one on the diagram.
I'm guessing that both coil packs going out is unlikely so i'm thinking it could be the igniter but where is it? Any specific grounds to look for?
I did find a two wire harness with the wires burned off. It's under the manifold from having the sequential system removed and wasn't connected.
powerfc
bnr twins
meth
exhaust
#2
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,894
Likes: 0
Received 114 Likes
on
66 Posts
Use the wiring diagram for the ignition and check all grounds and the 12 volt source to insure they are functional. Check if the igniter is putting out a signal. Check if the ECU is putting out a signal.
#3
Full Member
Thread Starter
iTrader: (3)
Join Date: Jan 2013
Location: georgia
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
I've got constant voltage at the coil packs. where is the igniter located?
What's a good way to check the signal I've got a klein multimeter that probably won't work.
What are the chances of my power fc being bad?
What's a good way to check the signal I've got a klein multimeter that probably won't work.
What are the chances of my power fc being bad?
#4
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,894
Likes: 0
Received 114 Likes
on
66 Posts
The igniter is left of the brake booster on the inner fender panel.
A volt meter can measure many low HZ signals.
Do not do this at home unless you know what you are doing and how to do it.
A volt meter can measure many low HZ signals.
Do not do this at home unless you know what you are doing and how to do it.
Thread
Thread Starter
Forum
Replies
Last Post