Trouble Shooting No crank, no start, no click, Hazard/horn are ON
#1
Full Member
Thread Starter
iTrader: (12)
Join Date: Jun 2008
Location: The City/SF
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
Trouble Shooting No crank, no start, no click, Hazard/horn are ON
I have a 1993 RX7 FD3S Base that having issue. Yes i search in the forum seem like most of them does not seem to have hazard/horn on like the vehicle im looking at. Vehicle does not start, no crank, no click, Hazard/horn are on, Dash is lit up with all the lights.
Battery is fully charge
Try jumping starter relay/clutch switch does nothing.
Visual check on the fuse at the engine bay. I will check ohm them to double check
Try to see if there is fault code with the paper clip at the diag port does not show any fault
I will be taking the starter out soon to bench test it to confirm the operation of it.
Sounds to be it is an immobilizer/alarm issue. Does anyone know how i can check/test this??
Thanks
Battery is fully charge
Try jumping starter relay/clutch switch does nothing.
Visual check on the fuse at the engine bay. I will check ohm them to double check
Try to see if there is fault code with the paper clip at the diag port does not show any fault
I will be taking the starter out soon to bench test it to confirm the operation of it.
Sounds to be it is an immobilizer/alarm issue. Does anyone know how i can check/test this??
Thanks
#3
RX-7 Bad Ass
iTrader: (55)
Flashing lights and horn are the security system going off. You can probably just unplug CPU #2 for troubleshooting purposes, that has the whole alarm system in it. Then figure out why it keeps tripping the alarm.
Also I would hook up the battery with the doors all unlocked. If it tries to flash/honk, put the key in door lock and lock/unlock the doors. If it's still doing it turn the ignition to On. If still doing it, go the CPU#2 route and troubleshoot more later.
Dale
Also I would hook up the battery with the doors all unlocked. If it tries to flash/honk, put the key in door lock and lock/unlock the doors. If it's still doing it turn the ignition to On. If still doing it, go the CPU#2 route and troubleshoot more later.
Dale
Thread
Thread Starter
Forum
Replies
Last Post
Enconsiderate
3rd Generation Specific (1993-2002)
12
03-09-04 04:44 PM
kelrx7r1
General Rotary Tech Support
8
04-13-02 09:11 AM
kelrx7r1
3rd Generation Specific (1993-2002)
14
04-04-02 11:39 PM