cewrx7r1

iTrader: (2)

We all know that the Efini "Y" pipe design is a lot better than the original one. Looking at them, it is obvious.

If you ever looked at the inlet pipe that bolts to the #2 turbo, you got to have said, "This is ****!". A "S" curve with squashed in areas. It is that way so it could also be used on Jap cars. Thus are left side drive cars get screwed.

A nice gentle bend is posible and there is room for it. Does anyone make a replacement?

One local Houston shop wants $275 to make one, and they need the car at their shop to do it.

rotorbrain

garfinkle has been thinking about it. ill ask him next time i talk to him. . . which will be soon. he may have decided to skip it. since there might be interest in such a piece ill remind him.

paul

duboisr

Garfinkle has got the tubing ( bends ) from Burns stainless for this job. He is waiting for the stages 3s to be smoke free before moving foward . I think the flanges were made already but I am not sure So much is going on I can keep stright what he tell me , hahaha. I think he has made all the tools to press out the rear end bushings and piller ***** .

rotorbrain

rock on!!! i really need to get over there and check out what he has done. evidently a lot since we last spoke. hes gonna make me sick isnt he!!! hahaha, he was "acting" envious when my car was up and running. . . now im envious (never wasnt really) of the new things hes done!!!

paul