Was testing boost and..
#1
Rotary Enthusiast
Thread Starter
Join Date: Jul 2003
Location: Toronto
Posts: 823
Likes: 0
Received 0 Likes
on
0 Posts
Was testing boost and..
Was in 5th gear feels kinda hard to get through 5th gear ??
Boost seems pretty strong up to about 4k rpm
and then when the transition is about to occur sometimes take a little long to get past 4500rpm at one point i had the pedal down to the floor and it was stuck at about 4k rpm....
Any one else experience this b4? could a belt being to tight have a problem like this ? or is this just a boost problem?
Boost seems pretty strong up to about 4k rpm
and then when the transition is about to occur sometimes take a little long to get past 4500rpm at one point i had the pedal down to the floor and it was stuck at about 4k rpm....
Any one else experience this b4? could a belt being to tight have a problem like this ? or is this just a boost problem?
#2
Rotary for life!
Yeah I have the same problem... I've never been through all of 5th.. on where near... not sure if its a problem... I have a big 5th gear 99spec, but yeah... haven't tried in a long time...
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM