When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
SPEC Mini Twin Clutch Hydraulic Push Bearing Installation
Just purchase and ready to install a SPEC Mini Twin Clutch and wonder if anyone has done one of this before. Will be installed in a 13B REW with OEM FD transmission setup. The clutch came with no installation instructions for the push type hydraulic bearing (see pictures). Do any of you installed one of this before, have pictures or instructions? Thanks
It's really easy to install. Wish I had a picture of mine to share. If I remember right, only 2 bolts are actually used. Just line 2 of the bolt holes to the trans where the lines can exit and you should be good to go.
I’m looking for a hydraulic release bearing to use on an RX8 with Tilton clutch. They seem to be few and far between. I did find one for the NB Miata that looks like it will work, but want to explore options. I don’t see this listed anywhere on the Spec website and was wondering if there’s any more information on it? EDIT: NM, I was on a Spec dealer website fauxing as the real thing, found the real Spec website.
I did see this from a Supra website and am not sure how old it may be, but they claimed the O-ring seals in the Spec hydraulic release aren’t brake fluid compatible? Seems hard to believe and maybe there was a supplier error, so any feedback is appreciated.
Also looking for a non-leak quick-disconnect to install on the main fluid line. I hate brake fluid and don’t want to deal with it leaking all over the place whenever the transmission comes out.
