RX7WEEE

iTrader: (16)

I got my M2 large SMIC on so i turned the boost and fuel up.

I'm running 12.5 psi.

It seems that in higher Rpms 7000-8000 the car is getting spark cut just like a very very very little bit. its not as smooth up there as it should be. I thought that i wasn't getting enough fuel up there so i richend it up even more with the PIM volt it didn't make any differnce

I dont think that I am running too much boost to need to upgrade the ignition yet.

Am i wrong?

Or is there something else that it could be?

i have searched but i couldn't find anything that helped me any links or info would be helpful.

my mods

DP, MP, CB, apexi intake, racing beat spark plug wires, powerFC, M2 large smic, light weight pullies.

dis1

Try replacing the plugs then throw it on a dyno.

RX7WEEE

iTrader: (16)

plugs are fairly new but ill try that

mad_7tist

how old are the coils? make sure the ground is clean and good, all of them actually

KaiFD3S

iTrader: (37)

check your fuel pressure also

matty

i get this is as well but it happens when i run greater than 14psi...i need an amp.