3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Sorry guys...but motor wont' run again..and need it running asap

Old Feb 13, 2010 | 10:40 PM
  #1  
oppa637's Avatar
Thread Starter
Rotary Enthusiast
Tenured Member: 15 Years
iTrader: (6)
 
Joined: Feb 2009
Posts: 1,247
Likes: 6
From: Houston
Sorry guys...but motor wont' run again..and need it running asap

So...to make it quick, have pretty much all block off plates. isc still there. Car was idling at 3k. Think I found the issue, cruise control was slight keeping butterflys open. Took cruise off. Car ran, idled at bout 1200 roughly. Then died. Found out map sensor got knocked off. Plugged back in...no start. De flooded, fresh gas, new spark plugs. Sounds like its starting, gets up to bout 600-800 rpms and then immediately dies. like...all in one motion. I can get a video if that helps. ANy clues?
Reply
Old Feb 14, 2010 | 06:45 PM
  #2  
millennm's Avatar
Full Member
Tenured Member: 20 Years
Liked
iTrader: (6)
 
Joined: Dec 2004
Posts: 167
Likes: 0
From: South Jersey
Test your fuel pressure.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
elfking
3rd Generation Specific (1993-2002)
3
Aug 19, 2015 09:48 PM
JZW
20B Forum
7
Aug 18, 2015 08:56 PM
Professorpeanutrx7
New Member RX-7 Technical
5
Aug 15, 2015 01:38 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 03:26 AM.