3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Sorry guys...but motor wont' run again..and need it running asap

Thread Tools
 
Search this Thread
 
Old 02-13-10, 10:40 PM
  #1  
Rotary Enthusiast

Thread Starter
iTrader: (6)
 
oppa637's Avatar
 
Join Date: Feb 2009
Location: Houston
Posts: 1,246
Received 6 Likes on 6 Posts
Sorry guys...but motor wont' run again..and need it running asap

So...to make it quick, have pretty much all block off plates. isc still there. Car was idling at 3k. Think I found the issue, cruise control was slight keeping butterflys open. Took cruise off. Car ran, idled at bout 1200 roughly. Then died. Found out map sensor got knocked off. Plugged back in...no start. De flooded, fresh gas, new spark plugs. Sounds like its starting, gets up to bout 600-800 rpms and then immediately dies. like...all in one motion. I can get a video if that helps. ANy clues?
Old 02-14-10, 06:45 PM
  #2  
Full Member

iTrader: (6)
 
millennm's Avatar
 
Join Date: Dec 2004
Location: South Jersey
Posts: 166
Received 0 Likes on 0 Posts
Test your fuel pressure.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
elfking
3rd Generation Specific (1993-2002)
3
08-19-15 09:48 PM
JZW
20B Forum
7
08-18-15 08:56 PM
Professorpeanutrx7
New Member RX-7 Technical
5
08-15-15 01:38 PM



Quick Reply: Sorry guys...but motor wont' run again..and need it running asap



All times are GMT -5. The time now is 08:45 AM.