I getting ready to do the swap as well. I will be using this thread for sure through out the whole thing.

 

hmm im planning on making the swap. but real quick question.

i got my auto fd for $8k so you think its better to do the swap? or just find a manual fd?

 

Do you still happen to have the how to archived somewhere? The site does not work anymore.

 

Has anyone reused the trans oil cooler as a second engine oil cooler when doing the swap?

 

https://www.rx7club.com/showthread.p...ans*+%2Bcooler

 

Thanks!!! Do you happen to also know if the stock 3.9 auto rear end will mount correctly with the manual driveshaft? I'm thinking it would reading through the swap threads, but nothing that out right said it.

 

You would need to change the companion flange to a 5 speed flange.

 

im doing the finish up work onyhe wireing harness on my 1994 tranny swap

 

Did mine for under 500 bucks (excluding clutch, it had a used one but I upgraded). Luckily I found a guy clearing out his garage

 

^^haha damn lucky you

 

lucky indeed! I got everything under an rx7 hood pretty much. I was thinking about putting the spare motor in my miata or rx8 but leaning towards the miata.

 

If you search I posted how to use the Auto harness and all you have to do is jumper to pins on the large connector for the auto transmission(starter interlock). It takes less than 2 minutes to complete all the "wiring" this way. You will still need to wire in reverse lights and a clutch switch if you want them.

 

thanks djseven i found them