Slow Boost
#1
Full Member
Thread Starter
Join Date: Mar 2001
Location: sunnyvale, Ca
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
Slow Boost
My 7 builds boost slower than I expected. I do get a 13-10-13 pattern but it takes a few seconds to build to 13. I have a P-FC, CWC air box, DP, N1 dual and stock IC. Some times it works right but usually not. Does this sound like a bad check valve? any other thoughts. My P-FC reads .91 max boost and .91 injecotr duty cycle.
Any ideas are greatly appriciated.
Thanks!
Any ideas are greatly appriciated.
Thanks!
#3
Rotary Enthusiast
iTrader: (2)
I have a slow build of boost as well. I am also wondering if I have a bad check valve and am loosing vacuum or pressure from the vacuum chamber or pressure chamber. They all check ok when the engine is cool, but I know that can be deceiving.
I might get four new aluminum VP-2CV Check Valves from http://www.perrypumps.com/prod03.htm and just change them.
I might get four new aluminum VP-2CV Check Valves from http://www.perrypumps.com/prod03.htm and just change them.
#4
A clogged cat will also cause slowER than normal boost build up. I doubt its a vacuum hose IF you get full boost at all. Depending on mileage then you'll know if its the cat or not. Mine builds a little slower due to my cat getting more clogged as time goes by. I have 109k miles on original cat and usually thats the time they like to go.
Engine performance mods are dp,cb,boost controller.
Engine performance mods are dp,cb,boost controller.
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
alexdimen
3rd Generation Specific (1993-2002)
20
10-23-15 01:50 PM