Ok so I am trying to install my RX-8 5speed shift **** I just got from the UK and I went out to my car and screwed it on and man it looks rediculous sitting so high. I have heard you put tape on the shaft and the boot wont slide down but I figured I would make an install write up with pics. I need to know the size thread maker or just what size of nut that fits on the threads.

thanks

mike

 

the shift boot should have a plastic collar which keeps it up high. No need to tape anything. I have that **** and it fits perfectly

 

yea but it is way to high for my taste. i want it lower. so i want to make more threads and cut off about a half inch of the shifter shaft

 

is this how yours looks? I can take a side pix if you want...

 

yea i cant really tell from the top.

 

i have that ****, i took out the shifter and cut an inch off, threaded it with a tap and die and screwed the new one on.

 

what size tap & die did you use on the threads? and an inch worked fine?

 

M10x1,25

 

My thoughts exactly on it sitting so high, I asked Bill about his and to my surprise its a stock shaft. Although in his picture it looks as though it sits lower than normal.

 

here ya go

 

damn it ...how did you make that low ...it looks really low , when i put mine on it it looks like some trucker ****

 

BTW .....your`e interior looks so clean wow

 

the shifter is shown in the neutral position. I just screwed it on as far as it would go...the car is stock with 36K on the odo.

 

the higher your shifter is sitting the longer throw u are gonna have between gears......meaning longer shifts

 

I was thinking the same thing when i put mines on , i think imma cut it and thread it now. isn't a inch too much though.